How To Assemble - Richell 803840 94961-0 Manual De Instrucciones

Parts
Before assembling this product, make sure the following parts are included:
Side Panel (2)
Rubber Skid
Settled width and the position of Fixing Bolts
l For the opening width less than 40.9"
Use Fixing holes A & B at top and D & E at bottom.
Fixing hole C
Fixing hole F
Fixing hole E
Fixing hole D
l For the opening width more than 49.6"
Use Fixing holes B & C at top and E & F at bottom.
Adjustment hole
Fixing hole C
Fixing Bolt
<Use as tension mount gate>

How to assemble

※Remove the zip tie on Pet Door before assembling. Then, determine
the direction of the door opening/closing.
※Use a Phillips-head screwdriver for assembly.
1.
Installation of Adjuster
Bolts/Knob and each Panels
①Install Adjuster Knob and Bolts into
Adjuster Bolt Receiver on the side of
Panel with Door and Adjuster Panel
as shown in right Figure.
②Set the gate against the wall at a perpendicular
angle. Then, attach Panel with Door and
Adjuster Panel using Fixing Bolts.
Pet Door
Panel with Door (1)
Fixing hole B
Fixing hole A
Fixing hole B
Fixing hole A
Fixing hole F
Fixing hole E
Fixing hole D
Adjuster Knob
Place Adjuster Knob in
the correct direction as
shown below.
View of Adjuster Knob
facing correct direction
Adjuster Bolt
Adjuster Panel (1)
l For the opening width 40.9 - 49.6"
Use Fixing holes A & C at top and D & F at bottom.
Fixing hole C
Fixing hole F
Fixing hole E
Position of each panels and direction of Fixing
Bolts (while looking down from above the top)
※Make sure to use correct direction and size of the holes
for Fixing Bolts.
Fixing hole Fixing hole
for bolts for bolts
Panel with Door
Adjuster Panel
How to screw Fixing Bolt
Fixing Bolt
Spring
Washer
Flat Washer
2
Adjuster Bolt Receiver
Spring Washer (8)
Adjuster Bolt (4)
Flat Washer (8)
Adjuster Knob (4) Fixing Bolt (8)
Fixing hole B
Fixing hole A
Fixing hole D
Fixing hole Fixing hole
for bolts for bolts
(Small) (Small)
Fixing hole Fixing hole
for bolts for bolts
(Large) (Large)
9 0 d
e g r e
e s