Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 50

USE - KETTLE

1.
Pull the lid upward and off of the glass container.
2.
If you only want to heat water take the tea strainer off of the lid by turning
it clockwise; keep it in a safe place.
3.
Pour in the desired quantity of clean, cold water. At least 0.5 litres water
must be poured in, the maximum fill level is 1.5 litres of water.
4.
Fit the lid onto the glass container with light pressure. Ensure that the lid is
properly fitted on, and in so doing note the marking on the lid.
5.
Connect the base to the mains supply (220–240 V~, 50/60 Hz).
6.
The red indicator light flashes as soon as the appliance is connected to the
mains supply.
7.
Switch on the appliance via the ON/OFF button.
8.
Select the desired water temperature via the respective button. The
appropriate indicator light lights up. The appliance heats up the water for
hygienic reasons and cools down to the desired temperature.
9.
As soon as the process is concluded a signal tone sounds three times.
10. If you do not switch off the appliance via the ON/OFF button, the appliance
will then keep the water hot for a maximum of 2 hours. As soon as the water
drops below the set temperature the water will be reheated.
11. You can interrupt the boiling process at any time by pushing the ON/OFF
button.
12. If you want to boil water again, please allow the appliance to cool off for a
few minutes.
13. Boiling water can cause scalding. Therefore, please handle the appliance
with care when it contains hot water.
14. The appliance is equipped with boil dry protection. When operated without
water or with excessive scaling, the appliance shuts off automatically. If
this happens, please allow the appliance to cool-down briefly before filling
it with water again or descale the appliance as described in the chapter
"Descaling".
15. Attention: If you take the glass container off of the base during the boiling
process, the appliance does not switch off. As soon as you place the
container back on the base, the previously selected boiling process will be
Stand 19.2.2020
Copyright UNOLD AG | www.unold.de
DE
EN
FR
NL
IT
ES
PL
19 von 68

Publicidad

Tabla de contenido
loading

Tabla de contenido