Working With The Mixer - Kompernaß KH 701 Instrucciones De Uso

Risk of injury from rotating parts!
To avoid personal injury and damage to the appli
ance, NEVER insert or place your hands or foreign
objects into the loading shaft. Only insert
ingredients by use of the stodger.
Only change accessories when the drive motor j
is at standstill! After being switched off, the drive motor
j continues to run for a short time. The appliance
may only be used when the drive openings not
being utilised are covered with drive protection lids.
In cases of malfunction switch the appliance off and
remove the plug from the wall socket, this will avoid
an unintentional switching on of the appliance.
On task completion
• Switch the appliance off with the rotary switch g .
• Turn the food processor u anti clockwise and
remove it.
• Disassemble the food processor u and clean all
parts (see chapter „Cleaning and care").

Working with the mixer

Risk of scalds!
Allow hot fluids to cool to a hand warm temperature
(ca. 30 40°C) before they are poured into the
mixer r .
Proceed as follows to prepare the appliance for opera
tion with the mixer r :
• Press the unlocking button f and bring the
swivel arm h into operating position 3 (see
chapter „Operating positions").
• Remove the drive protection lid for the mixer
(Fig. 7).
• Fit the mixer r (Marking on the base onto the
marking on the base machine) and turn it
anti clockwise as far as it will go (Fig. 8).
• Fill with ingredients.
Maximum amounts: 1 litre;
foaming liquids, maximum 0,5 litre; optimal
processing amount for solids: 50 100 g
Note: Take note of the table in the chapter
„Recommended filling quantities".
• Place on the lid with funnel and press it down
firmly (Fig. 9).
• Set the rotary switch g to the desired level.
Risk of injury from sharp knife/rotating
drive!
NEVER reach into the mixer r when it is in use!
Remove/place the mixer r only when the drive
motor j is at stillstand! Only use the mixer r
with the lid firmly in position.
In cases of malfunction switch the appliance off and
remove the plug from the wall socket, this will avoid
an unintentional switching on of the appliance.
Refilling with ingredients
• Turn the appliance off with the rotary switch g .
• Press the button on the handle of the mixer r ,
remove the lid and fill with ingredients
or
• remove the funnel and slowly refill with solids
through the refill opening (Fig. 10)
or
• refill with fluid ingredients by means of the
trichter (Fig. 11).
On task completion
• Switch the appliance off with the rotary switch g .
• Turn the mixer r clockwise and remove it.
Note: The mixer r is best cleaned immediately
after use (see chapter „Cleaning and care").
- 26 -