Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
APPLICATIONS
Removal of casting fin and finishing of various type
of steel, bronze and aluminum materials and
castings.
Grinding of welded sections or sections cut by
means of an acetylene torch.
Grinding of synthetic resins, slate, brick, marble.
WARNING:
To avoid the risk of serious injury, NEVER use this
grinder with cup wheels and/or saw blades.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
How to install the battery.
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a little click. If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you. (Fig. 3)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latches (2 pcs.) on the sides of the
battery. (Fig. 3)
Latch
Insert
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
ASSEMBLY AND OPERATION
Battery
Push
Pull out
Fig. 3
WARNING:
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1.
Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been inserted
into the receptacle, the charge status lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged.
immediately.
2.
Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4. Make sure it contacts the bottom of the
battery charger.
Charge status
lamp (red)
Overheat lamp (green)
3.
Charging
When the battery is connected to the battery
charger, charging will commence and the pilot
lamp will light in red. (See Table 2)
NOTE:
If the pilot lamp flikers in red, pull out the plug
from the receptacle and check if the battery is
properly mounted.
English
Have
it
repaired
Battery
Fig. 4
11
Publicidad
Tabla de contenido
