Safety Precautions; Safe Usage Conditions; Preparation For Launching - Aquael STERILIZER UV PS Serie Instrucciones De Funcionamiento

Before the installation and every starting of the device, carefully
read this installation and maintenance manual.
 When performing any works conducted in the water reservoir (start-
up, maintenance), disconnect the device from the mains by pulling
the plug out of the socket.
 The device emits ultraviolet radiation that is harmful to human skin
and eyes. Never operate the device with its housing removed!
 The device should only be powered from an electricity network with
the nominal parameters (voltage and frequency) specified on the
housing of the device, using a socket located in a dry place. The
power supply network should be equipped with a residual-current
circuit breaker with a leakage current of 30mA.
 If the device is damaged, disconnect it from the mains immediately.
Do not operate the device if its power cord or quartz glass shield is
damaged. Do not repair or replace the power cord!
 When there is a risk of freezing, switch off the sterilizer, drain the
water, and store the sterilizer until spring in a place protected from
frost.
 Depending on your country, other special regulations may ap-
ply to the use of the sterilizer.
 The device employs a UV-C lamp. Accidental use of the device or
damage to its housing may lead to the release of hazardous UV-C
radiation. The UV radiation emitted by the bulb employed in the
sterilizer is harmful to human eyes and skin even in small amounts.
Do not use the device outside of its housing, nor stare directly at
the UV-C bulb when in operation! The bulb should not be used with
power sources other than specified by the device manufacturer. Be-
fore opening the device, read the manual. Always disconnect the
device from the mains before replacing the UV-C bulb.
 This device can be operated by children who are at least eight years
of age, by persons with reduced physical or mental capabilities or
persons with no prior experience with the device only under super-
vision or following aninstruction on the safe operation of the device
to ensure that the person is aware of any associated risks. The
device is not a child's toy! Do not let children to clean or perform
maintenance on the device without supervision.

PREPARATION FOR LAUNCHING

I. INSTALL THE FLUORESCENT LAMP
Prior to launching the sterilizer, insert the fluorescent lamp, pro-
ceeding as follows:
1. turn the fitting grip (10) clockwise, according to the „OUT" arrow
(fig. ),
2. remove the fitting (10),
3. press the fluorescent lamp (8) into the fitting (10) until locked,
NOTE Do not touch the fluorescent lamp glass; remove possible
marks with a dry cloth.

SAFETY PRECAUTIONS

STERILIZERUV ps
9