id ethnos CONFETTI Manual Del Usuario página 17

4). Do not cut the CONFETTI and leave it too close to the upper base of
the foot, as it can disrupt the movement. We advise that it has a slack
of 5mm;
3. Attach both parts of the cover to delimit the place where the back
should be cut. Perform the cut in the same manner as in the previous
step;
4. Fit the cover on the prosthesis to correctly mark the location where
the tube will be located. (Image 5);
For the CONFETTI, use one of the accessories located in the kit that
accompanies the package. If one of the accessories is placed improper-
ly, the CONFETTI'S attachment may become unstable.
4.1. Adhesive tape – for 34 mm tubes. (Image 6);
4.2. Ring clip – for 30 mm tubes (thin tubes) (Image 7);
Check an example on how to use the accessories on image 8.
5. Attach the cover to the prosthesis using the magnets and screws.
Caution!
* After the cover is cut, there is no possibility to glue or readjust it.
* We advise you to find a qualified professional to carry out the cutting
adjustments.
* When placing the ring clip on your prosthesis' tube, be careful not to
open it too much or it may break.
8. TECHNICAL SPECIFICATIONS
8.1 CONFETTI
IMPORTANT: * The measurement units are displayed in cm and g.
SPECIFICATIONS
Frontal height (cm)
Overall frontal width (cm)
Frontal part depth (cm)
Rear part height (cm)
Rear part depth (cm)
8.2 CONFETTI TT
SPECIFICATIONS
Total weight (g)
MEASUREMENTS
48
11
6
40
5
aprox. 585
MEASUREMENTS
User Manual | 17