Led Indicators; Cleaning And Care - GUTMANN EM 05 S Instrucciones De Uso

en
Operation via Switch
Ceiling Device below the Pane)
Pressing the switch to the left: Light ON/OFF
Pressing the switch to the right: Regulation
of the power level
Pressing the switch to the right for 3 seconds:
hood is turned off.
The filter saturation display is also reset using
this switch. To do so, press the switch to the
right until the red LED turns off.

LED Indicators

(Located on the Ceiling Device)
Information regarding the operating
conditions of the hood can be read on the
device's LED indicators:
Indicators
C o o l D o w n
L e v e l 1 :
L e v e l 2 :
L e v e l 3 :
In t e n s iv e L e v e l:
F ilte r S a t u r a t io n In d ic a t o r :
LED 1: Indicates operational status ON/OFF
LED 1 blinking: Indicates automatic cool down
period (the hood will automatically decrease
by one power level every 5 minutes until it
finally turns off)
LED 2: Power level 1 (lowest motor speed),
press button 2 on the remote control once
(Located on the
- +
G r e e n L E D
:
G r e e n L E D
G r e e n L E D
G r e e n L E D
G r e e n L E D
LED 3: Power level 2 (middle motor speed)
Press button 2 on the remote control twice
LED 4: Power level 3 (high motor speed)
Press button 2 on the remote control three
times
LED 5: Intensive level (motor automatically
returns to level 3 after 3 minutes)
Press button 3 on the remote control
LED 6: Filter Saturation Indicator
The metal filter must be cleaned when the
red LED lights up (see section on cleaning
and care).

Cleaning and Care

Cleaning the Surface
Risk of Electrical Shock!
Separate the exhaust hood from the electrical
supply by removing the plug from the outlet
or tripping the fuse. Please make sure that
no water enters the device during cleaning.
Early cleaning of the surfaces prevents
toilsome removal of deep-rooted debris later.
Please only use standard detergent or all
purposes cleaners which are suitable for
stainless steel/aluminum surfaces. Never use
scouring cleaners or steel wool.
After cleaning the hood, treat the stainless
R e d L E D
steel surfaces with an appropriate preserving
agent. Painted surfaces should be cleaned
with a mild detergent and a very soft cloth.The
control panel must only be cleaned with a soft,
damp cloth.