Ecoflam MAXFLAM 30 AB Manual De Uso página 8

EN
Function
­ General safety functions
Operating function
- Switch-on the burner. When reaching
the preset temperature on the working
thermostat, and with boiler's thermostat
closed, the control box starts the fan,
the fuel pump and the ignition
transformer. At the same time, the
resistors are activated, to keep fuel
temperature into the heater at a
constant value.
- The motor starts, the igniter is switched
on and the preventilation period of 25
seconds commences.
- During the preventilation period, the
furnace is monitored for flame signals.
- At the end of the preventilation period,
the fuel-oil solenoid valve opens and the
burner starts.
- The igniter remains switched off while
the burner is in operation.
Controlled shutdown
- Boiler thermostat interrupts heat
request.
Legend :
A. Low Flame solenoid valve (N.C.)
B. High Flame solenoid valve (N.C.)
D. Orifice.
E. Tank..
F. Anti-gas valve.
G. Heater.
H. Filter.
I. Fuel pump.
N. Manometer.
O. Solenoid valve (N.O.).
N.C. = Norm. closed
N.O. = Norm. open
8 www.ecoflam­burners.com
- The fuel-oil solenoid valve closes and
the flame is extinguished.
- Burner motor switches off.
- Burner enters standby.
Safety function
A safety shutdown occurs:
- if a flame signal is present during
preventilation (parasitic flame
monitoring).
- if no flame is produced within 5 seconds
(safety time) of start-up (fuel
authorisation).
- if no flame is produced after an
unsuccessful restart attempt in the
event of flame failure during operation.
A safety shutdown is indicated by the
malfunction lamp lighting up and it is then
only possible to reenable the burner by
pressing the reset button after the cause
of the malfunction has been rectified.
For further information, see the
automatic combustion control unit
description.
D
O
B
F
N
H
G
E
420010537801
A
I