Genius ROLLER Manual Del Usuario página 9

The ROLLER automation system for swing gates is a geared motor. It is
designed for underground installation and therefore does not alter the
appearance of the leaf.
The foundation box of the automation system comes ready to take an
operator.
The ROLLER electromechanical operator is irreversible, so it ensures a mecha-
nical stop and eliminates the need to install an electric lock.
The ROLLER automated systems were designed and manufactured to
control access of vehicles. Avoid any other use whatever.
1. DESCRIPTION AND TECHNICAL CHARACTERISTICS
Foundation box
Bores for fastening boxcover
operator
Support bracket for gate
Locking bracket
Release device with key
Crank and connecting rod
assembly
Model
Power supply (Vac) (Vdc)
Power (W)
Current (A)
Thermal protection (°C)
Capacitor (µF)
Max torque (Nm)
Angular velocity (°/sec)
Max. leaf (m)
Leaf opening angle (°)
Use type and frequency
20 (110° e
Minimum indicative hourly
cycles
36 (140°)
Operating ambient tempera-
ture (°C)
Operator weight (Kg)
Protection class
Operator dimensions (mm)
Box dimensions
AUTOMATION SYSTEMS ROLLER
Pinion
Bore for power supply cable
pipe
Bore for drain pipe
Fastening screws for operator
Lubrication bore
Boxcover
Plug of closing
Roller Roller Roller
Roller 24V
Lento 230V 115V
230 115
300 380 600
1.3 1.7 5.3
140
12.5 30
250 330
4 6 7
3.5 (110°) - 3 (180°) - 2 (140°)
110 (140 and 180 with kit)
S3 - 30% 100%
100 (110°
30 (110° e 180°)
180°) e 180°)
50 (140°)
170 (140°)
-20 ÷ +55
26.5
IP67
360 x 150 x 140
See figura 2
3. MAXIMUM USE CURVE
The curve makes it possible to
establish maximum work time (T)
according to use frequency (F).
With reference to IEC 34-1 stan-
dard, the ROLLER gearmotor ope-
rating at S3 service, can function
at a use frequency of 30%.
To ensure efficient operation,
operate in the work range below
the curve.
The curve is obtained at
a temperature of 20°C.
Exposure to the direct
sun rays can reduce use
frequency down to 20%.
C
ALCULATION OF USE FREQUENCY
The percentage of effective work time (opening + closing) compared to
total time of cycle (opening + closing + pause times).
Calculation formula:
% F = ––––––––––––––––––– X 100
Fig. 1
where:
Ta = opening time
Tc = closing time
Tp = pause time
24 Ti = time of interval between two complete cycles
70
4. ELECTRIC EQUIPMENT (STANDARD SYSTEM)
3
/
/
300
6
Operators ROLLER (require 2 junction boxes)
Photocells
Control unit
Pushbutton
Flashing light
To lay electrical cables, use adequate rigid and/or flexible tubes.
Always separate low voltage accessories from those operating at
230/115 V~. To avoid any interference, always use separate shea-
ths.
7
2. DIMENSIONS
Use frequency graph Use frequency graph
Ta + Tc
Ta + Tc + Tp + Ti
Fig. 2
Fig. 3