Installation - Pioneer DEH-9350SD Manual De Instrucciones

Section

Installation

03
This unit
1 2 3 4 5 6
7
1 Antenna input
2 Fuse (10 A)
3 Power cord input
4 Wired remote input
Hard-wired remote control adaptor can be
connected (sold separately).
5 Front output
6 Rear output
7 Subwoofer output
Power cord
Perform these connections when not connect-
ing a rear speaker lead to a subwoofer.
1
L
2

4
6 8
F
7 9


5
c
R
b d

e
f
g
h
i
12
En
Perform these connections when using a sub-
woofer without the optional amplifier.
1
L
2

4
6
F
7


j
b
SW

e k
f
g
l
h
i
1 To power cord input
2 Left
3 Right
4 Front speaker
5 Rear speaker
6 White
7 White/black
R
3 8 Gray
9 Gray/black

a Green

b Green/black
c Violet

d Violet/black

e Black (chassis ground)
Connect to a clean, paint-free metal location.
f Yellow
Connect to the constant 12 V supply termi-
nal.
g Red
Connect to terminal controlled by ignition
switch (12 V DC).
h Blue/white
Connect to system control terminal of the
power amp or auto-antenna relay control ter-
minal (max. 300 mA 12 V DC).
Installation
i Orange/white
Connect to lighting switch terminal.
j Subwoofer (4 Ω)
k When using a subwoofer of 70 W (2 Ω), be
R
sure to connect the subwoofer to the violet
3
and violet/black leads of this unit. Do not

8
connect anything to the green and green/
9

black leads.
l Not used.

c
m Subwoofer (4 Ω)× 2
d

Notes
! With a 2 speaker system, do not connect any-

c
thing to the speaker leads that are not con-
m
nected to speakers.
b ! Change the initial setting of this unit. Refer
d

to S/W control (rear output and subwoofer
setting) on page 10.
The subwoofer output of this unit is monau-
ral.
Power amp (sold separately)
Perform these connections when using the op-
tional amplifier.
1

5

1

7

1

9

1 System remote control
Connect to Blue/white cable.
2 Power amp (sold separately)
3 Connect with RCA cables (sold separately)
4 To Rear output
5 Rear speaker
6 To Front output
7 Front speaker
8 To subwoofer output
9 Subwoofer
Installation
Important
! Check all connections and systems before
final installation.
! Do not use unauthorized parts as this may
cause malfunctions.
! Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
! Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
! The semiconductor laser will be damaged if
it overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
unit is installed at an angle of less than 60°.
3
2
4

5

3
2
! To ensure proper heat dispersal when using
6

this unit, make sure you leave ample space
7

behind the rear panel and wrap any loose ca-
3
bles so they are not blocking the vents when
2
installing the unit.
8

9
DIN front/rear mount

This unit can be properly installed using either
front-mount or rear-mount installation.
Use commercially available parts when instal-
ling.
60°