Rexel Auto+ 100 Manual De Instrucciones página 6

Autofeed Technology
The Auto+ 100 has been designed to automatically shred up
to 100 sheets from the autofeed chamber and up to 6 sheets
through the low sheet count slot. The patented autofeed
mechanism has been designed to handle paper fastened with
staples and paper clips and to only pull a few sheets of paper
into the cutting mechanism to minimise the risk of paper jams.
The stack of paper does not need to be prearranged before
loading into the chamber.
To load the shredder, simply press the loading door button
which automatically opens the loading door and insert
documents. You can open the door further to 90 degrees
for easier access if required. Closing the loading door will
automatically start the shredding cycle.
Bin or Loading Door Open Safety
Function
As a safety precaution, if the bin or loading door is opened
during shredding, the shredder will stop, and the bin full /
loading door open indicator (
Rare Occasions of Jamming
In the unlikely event of the shredder jamming, the Auto+ 100
will automatically reverse and forward the engine three times to
clear a jam. If after this auto jam clearance cycle the shredder
still has a paper jam, it will stop and the jam indicator illuminate
( ). Try clearing the jam using the reverse and continuous
jam boost ( ) buttons. If this is unsuccessful, open the
loading door, remove the remaining stack of paper, then pull the
jammed paper free of the cutting mechanism.
Over Heating
If the Auto+100 is used continuously for over 10 minutes
the shredder may overheat and the cool down indicator will
illuminate ( ). Please allow the shredder to cool down. When
the shredder is ready to be used the thermometer symbol will
no longer illuminate. If the shredder needs to cool down while
shredding, no action is needed. The shredder will automatically
restart shredding paper once it has cooled down after periods
of continuous use. All you need to do is ensure paper is loaded
into the chamber and the bin is empty when the machine is
cooling down.
6
) will illuminate.
Operation
After unpacking the product, pull out the shredder bin.
1
Remove and fit the recyclable paper bag (as per instructions
printed on the bag).
Connect the shredder to mains supply.
2
Ensure the on/off button on the back of the machine is in
3
the on position.
To commence shredding, press the central Auto button
4
( ). This will illuminate the blue standby symbol on the
auto button and sets the shredder into auto mode. You are
now ready to shred.
Press the loading door button to open the loading door.
5
Load up to 100 sheets at a time into the feed chamber. Do
not fill above the 100 MAX level, this could damage the
shredder (see fig 1).
Close the loading door without pressing the loading door
6
button. The shredder will now start automatically.
If you only have up to 6 sheets to shred, you can use the
7
low sheet count slot, provided the auto feed chamber is
empty (see fig 2).
If the shredder is left in auto mode for more than 2 minutes
8
without being used, it will automatically turn to standby
mode to save power.
The shredder will automatically operate from standby
9
mode when paper is inserted into the low sheet count slot.
Opening either the loading door, empting the bin or pressing
any button will return the product to auto mode.
Reverse Function
Should you wish to reverse paper out whilst shredding, a
1
reverse button ( ) has been fitted for your convenience.
The jam indicator will illuminate.
The reverse function will only run whilst the button is being
2
pressed. When the reverse button has been released the
shredder will revert to auto mode.