Publicidad
Idiomas disponibles
Idiomas disponibles
battery cartridge when you notice less tool
power.
2.
Never
recharge a fully charged
cartridge.
Overcharging shortens the battery service life.
3.
Charge the battery cartridge with room
temperature at 10 ﾟ C - 40 ﾟ C (50 ﾟ F - 104 ﾟ F).
Let a hot battery cartridge cool down before
charging it.
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the cleaner is switched off and
•
the battery cartridge is removed before adjusting or
checking function on the cleaner.
Installing or removing battery cartridge
1
2
3
011112
Always switch off the cleaner before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the cleaner while sliding the button on the front of
the cartridge as shown in the figure.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can
see the red part on the upper side of the button, it
is not locked completely. Insert it fully until the red
part cannot be seen. If not, it may accidentally fall
out of the cleaner, causing injury to you or
someone around you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Battery protection system
The cleaner is equipped with the protection system,
which automatically cuts off the output power for its long
service life.
The cleaner stops during operation when the cleaner
and/or battery are placed under the following situation.
This is caused by the activation of protection system and
does not show the cleaner trouble.
battery
1. Red part
2. Button
3. Battery
cartridge
4
When the cleaner is overloaded:
•
At this time, press the "OFF" button and
remove causes of overload and then press
the "HIGH/LOW" button again to restart.
When battery cells get hot: (refer to the note below.)
•
If any operation of the "HIGH/LOW" button
and the "OFF" button, the motor will remain
stopped. At this time, stop use of the cleaner
and cool or charge the battery cartridge after
removing it from the cleaner.
When the remaining battery capacity gets low:
•
If any operation of the "HIGH/LOW" button
and the "OFF" button, the motor will remain
stopped. At this time, remove the battery
cartridge from the cleaner and charge it.
NOTE:
This temperature-sensitive protection is applied
•
only when the cleaner is used with a battery
cartridge with a star mark.
1
011389
Switch action
2
011121
To start the cleaner, simply press the "HIGH/LOW"
button. To switch off, press the "OFF" button. To change
the cleaner speed, press the "HIGH/LOW" button. The
first press on this button is for high speed and the
second press for low speed and then each press on this
button repeats the high/low speed cycle alternatively.
1. Star mark
1. HIGH/LOW
1
button
2. OFF button
Publicidad
