Tabla de contenido
Publicidad
/
/
7
D I A G R A M A
S C H É M A
F I G U R E
Replacing Pages
1.
To replace pages. Turn the machine on and allow time to warm up.
2.
Find pages to edit. Fold the corner(s) of the page(s) to be replaced.
3.
Lay the document on a work surface and open it flat, behind the page
to be replaced. Position the new, replacement page as far into the
document and as close to the adhesive as possible. Close the document.
4.
Insert bound document. Place document spine down in the machine.
Position the document flush to the right side of the opening.
5.
Press the Bind Button and hold for 2 seconds. Wait for the clamps to
open — approximately 20 seconds.
6.
Immediately remove the page to be replaced. With the document still
in the binder, grasp the page by a top corner and gently but firmly pull
upward, peeling the page away from the spine from left to right (or
right to left). Gently tap the top edge of the replacement page to
ensure that is even with the other pages in the document.
7.
Remove the bound document. Remove the document from the
machine and place it spine down in the Cooling Rack. Allow it to cool
for approximately 5 – 7 minutes.
If the page does not come out easily, repeat steps 4 – 7 above.
'
M O D E L
1 1 U S E R
S
M A N U A L
11
Publicidad
Tabla de contenido
