Maintenance Checklist - Bostitch SF150C Manual De Operación Y De Mantenimiento

Maintenance
Inspect trigger
performance
Drain condensation from
air compressor tanks
and air filters (if present)
Clean magazine
assembly
Clean nose assembly
Ensure all fasteners
remain tight
Check/clean air inlet air
filter
Replace no-mar tip
Replace swivel air fitting
Replace piston/driver
assembly
Replace O-rings
Replace bumper
Replace headvalve
Replace engine cylinder
Benefit
Ensure trigger system is
in proper working order
Prevents accumlation of
moisture that can impede
tool performace
Prevents accumlation of
debris that could cause a
jam
Prevents accumlation of
debris that could cause a
jam
Prevent loose parts
Maintains proper air
flow to engine for peak
performance.
Prevents marks in
softwood applications
Maintains proper air
flow to engine for peak
performance
Maintains consistent
drive quality
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance

MAINTENANCE CHECKLIST

Procedure
Refer to Tool Operation
Check section in this
manual
Open drain cock on tanks
and air filters and drain
all condensate
Blow clean with
compressed air
Blow clean with
compressed air
Tighten all fasteners with
appropriately sized hex
wrench
Remove end cap and
use compressed air blow
gun to blow filter clean.
Replace filter as required.
Remove worn no-mar tip
and replace with a new
tip (a spare tip is located
on the magazine)
Remove worn swivel air
fitting and replace with
new swivel fitting
Refer to replacement part
kit instructions
Refer to replacement part
kit instructions
Refer to replacement part
kit instructions
Refer to replacement part
kit instructions
Refer to replacement part
kit instructions
- 13 -
Service Interval
Daily
Daily
Daily
Daily
Weekly
25,000 Fasteners,
or monthly - if
used in dusty
location
25,000 Fasteners
50,000 Fasteners
250,000 Fasteners
250,000 Fasteners
250,000 Fasteners
250,000 Fasteners
500,000 Fasteners