Kasco 2400EVFX Manual Del Propietário página 7

3400EJF, 4400EJF Assembly
STEP ONE
Set motor housing upright (stainless steel can down)
on a fl at surface. With motor housing upright, slide
Float (Part 2) over pump housing making sure the
surface with the Kasco logo is up.
3
4
5
6
7
Rest the fl oat on the cage top ring.
STEP TWO
2
Ensure correct alignment by twisting the fl oat gently
around the motor housing until the power cord guide
lines up with the cord. See diagram of bottom side of
fl oat.
1
power cord
guide
8
9
STEP THREE
Use one of the 1/4"-20 x 3-1/4" Phillips Pan Head
10
Screws (Part 3), one 1/4" split washer (Part 4), and a
1/4" Flat Washer (Part 5) to secure the fl oat. Make
sure the split washer goes between the bolt head and
11
the fl at washer. Insert screw with washer through bolt
hole in fl oat.
12
Use one fl oat retaining clip (Part 8) under the top ring
of the cage. There is a U-shaped indent in the clip
that will fi t snug against the top ring of the cage. The
1/4"-20 x 3-1/4" will then thread into the retaining
clip.
logo
Bolt holes
fl oat retain fl oat retain
ing clip ing clip
7