Electrical Requirements; Accessory Installation - Whirlpool LWFR3100 Instructivo De Instalación, Uso Y Manejo

ELECTRICAL REQUIREMENTS

If the range has accessories that need a power supply, make sure the installation is close from
a wall outlet.
The plug has to be connected to a power supply of 105 - 140 V ~. Make sure the installation is
properly grounded.
When the gas installation is done, connect the range to the electric supply.
Electrical Specifications for Power Supply:

ACCESSORY INSTALLATION

Installation of back panel (in some models.)
If your appliance is equipped with a back panel, follow these steps for installation:
1. Unpack the backrest found on top of the stove.
2. You will find attached to the backrest stove, 2 deck spacers,
2 standard screws and 2 long screws.
3. With the help of another person, place the backrest behind
the cover, and verifying that the holes, both the backrest and the
cover, are aligned.
4. Install the 2 screws (B), as shown in the figure.
5. For the correct operation of your stove, MUST be installed on
the back of the cover, the spacers with the screws, as indicated
in the figures. The spacer is placed in both sides of your stove,
as illustrated in the following figure.
34
WARNING
Always use pipes and valves approved by the local regulations.
Verify the integrity of pipes and gas regulators, replace them if necessary.
Tight all gas connections during the installation.
Install this appliance according to the specifications in this manual.
Not follow these instructions may cause explosion, fire or possible injure
people.
WARNING
Do not use an extension cord.
Don t use the product without ground prong.
Don t use universal plugs.
Unplug the power supply before giving maintenance.
Do not remove ground prong.
Failure to follow these instructions can result in death, fire, or electrical shock.
105 - 140 V ~ Frecuency: 50/60 Hz Current: 1,0 A Max
Explosion Hazard
Electrical Shock Hazard
B