Range Use - Whirlpool LWFR3100 Instructivo De Instalación, Uso Y Manejo

Oven Burner Flame
The different altitudes from the sea level, the variations on the gas supply line and the type gas
conversion may cause the need to adjust the primary air intake in the oven burner for an adequate
air-gas blend, and therefore a better performance of the burner.
The oven burner flame should be blue colored and steady, follow these steps to adjust the flame:
1. Check the range is cold and all the cooktop burners are in the OFF position.
2. Unplug the range or turn off the power supply. Remove the shelf on the bottom of the oven.
Grab the shelf from both sides on the back part (see image below), pull out and remove.
3. Locate the screw that holds the burner to the frontal range chassis and use a small flat
screwdriver to remove it. Place the screw in a safe place.
4. Hold the burner and pull it off to release the back
part from the nozzle, try not to pull the pigtail on the
back if your range is equipped with electronic ignition.
5. To adjust the air, loose the air regulator screw
located behind the burner and turn to open or close the
air window (see image).
6. If the flame is yellow you need to open the window. When the flame is noisy or levitates our
of the burner you need to slightly close the window.
7. When the adjustment has been done, tighten the air regulator screw and set the burner to
its original position, align with the nozzle on the back and make sure the pigtail is set to the back
of the range.
8. Place the screw with the washer holding the frontal range frame and the burner. Tighten the
screw.
9. Connect the power cable or turn on the power supply.
10. Turn on the burner again following the steps on section "Testing your Range", "Oven
Burner". If the flame is steady and blue, the range is ready to use. Otherwise wait until the range
is cold and return to step 3.
11. When the oven burner has been adjusted and placed inside the oven, replace the bottom
shelf to its original location. Continue with the oven burner testing.
NOTE: Don't block the air outlet of the oven, don't wrap or cover the vents in the oven shelf.

RANGE USE

Cooktop Controls
The electronic ignition burners turn on the outer burner automatically when the knob is turned to
Hi (High flame). See "Testing your Range", "Cooktop Burners".
Before turning ON one of the burners, place the cookware with food over the cooktop. Don't turn
on a burner with an empty cookware or without it.
To set the burner temperature:
1. Push and turn the knob to the left. The
burners will click but only the active burner will
turn on.
2. Turn the knob to any position between Hi
(maximum flame) and Low (minimum flame) or
Hi (maximum flame), Medium (medium flame)
and (minimum flame). The click will stop.
37