Features - PowerStroke PS906025 Manual Del Operador

PRODUCT SPECIFICATIONS
ENGINE
Engine Type .............................. Air Cooled Overhead Valve
Spark Plug ...............................................Torch or LG F6TC
Engine Lubricant Volume........................................... 37 oz.
Fuel Volume ................................................................ 6 gal.
GENERATOR
Rated Voltage ...................................................120V / 240V
Rated Amps ......................................................... 50A / 25A
*Rated running watts determined by PGMA Standard G200
KNOW yOUR GENERATOR
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AC CIRCUIT BREAKERS
The circuit breakers are provided to protect the generator
against electrical overload. The circuit breaker may be reset
by pressing the circuit breaker reset button.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
CHOKE LEVER
The choke lever is used when starting the engine.
DIGITAL DISPLAy
The digital display shows AC voltage output, frequency, how
long the engine has been running during the current usage
period, and the total number of hours the unit has been used.
EXTENSION CORD
A 25 ft. extension cord equipped with a twist-lock plug on
one end, two circuit breakers and four 120V receptacles on
the other is provided with the generator.
FUEL TANK
The fuel tank has a capacity of 6 gallons.
FUEL VALVE
Fuel flow from the fuel tank to the engine is turned on and
off using the fuel valve.

FEATURES

Rated Running Watts* ............................................6,000 W
Rated Starting Watts ..............................................7,500 W
Rated Frequency ........................................................60 Hz
DIMENSIONS
Length ........................................................................ 29 in.
Width ....................................................................... 23.9 in.
Height ......................................................................... 24 in.
Weight .................................................................... 194 lbs.
GROUND TERMINAL
The ground terminal is used to assist in properly ground-
ing the generator to help protect against electrical shock.
Consult with a local electrician for grounding requirements
in your area.
LOW OIL SHUT DOWN PROTECTOR
The low oil sensor causes the engine to stop if the level of
lubricant in the crankcase is insufficient.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
OIL DRAIN PLUG
When changing the engine lubricant, unscrew and remove
the oil drain plug to allow old engine lubricant to be drained.
RECEPTACLES
Your generator has the following single phase, 60 Hz out-
lets: one 240 Volt AC 30 Amp twist lock receptacle and two
120 Volt AC, 30 Amp duplex receptacles. These can be used
for operating appropriate appliances, electrical lighting, tools,
and motor loads.
RECOIL STARTER GRIP
The recoil starter grip is used to start the generator's engine.
STOP SWITCH
The generator has a stop switch near the fuel valve. To turn
the engine off, press and hold the STOP switch until the
engine stops.
Page 10 — English