Components And Controls; Operating Conditions; Remote Controller - ECG AH D501T Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 88

COMPONENTS AND CONTROLS

High performance of the humidifier.
Water softening water filter. Extends the life of the humidifier.
Air Purifier Function – Built-in HEPA and active carbon filter cleans air.
AROMA function.
Night mode.
Automatic switch off when the water tank is removed.
Automatic switch off in case of lack of water.
PLACING THE APPLIANCE
GB
Place the appliance on a firm, level surface.
1.
The humidifier has to be placed on a level surface and be stable.
2.
Do not place the humidifier close to sources of heat.
The humidifier must not be placed near heat sources such as kitchen ranges, stoves or fireplaces. Do not
place the humidifier in direct sunlight.
Do not place the humidifier close to furniture and electronic devices.
3.
The mist stream coming out of the humidifier should not be directed to furniture and electronic equipment
to prevent moisture damage.
Thank you for purchasing our ultrasonic humidifier. In order to safely and efficiently use all the functions of this
device, read this user manual carefully and save it for future reference.
OPERATING INSTRUCTIONS

Operating conditions

If the relative humidity in the room is more than 70% or the room is closed, we recommend setting the
humidifier to a low intensity.
1.
The operational environment for the humidifier is at temperatures between 5 ° C and 40 ° C degrees Celsius
and relative humidity lower than 80% RH.
2.
Use clean, cold water (distilled water is recommended).
3.
After a long break in using, clean the water tank and all components of the appliance where water flows
to the steam generator.
4.
If there is a water filter in the humidifier, it is recommended to soak it for 24 hours before first use.

Remote controller

Before use, insert the button cell battery (CR2025, 3V) included in the package in the
remote controller. Open the cover and insert the battery into the controller as shown
on the remote controller cover. Keep proper polarity of the battery. If you will not be
using the appliance for a long time, remove the battery from the remote controller.
If the battery is discharged, replace it with a new one of the same type.
Note: When using the remote controller, aim it at the sensor located on the device.
If there are obstacles between the remote controller and the sensor, the signal
may not be transmitted.
46
No essential oil spill or
drip into the sink!
Be careful, high
temperature.
Push
Release
Open

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido