F3 - Terminal Menu - KERN KMN-TM Manual De Instrucciones

F2.2.3 – Upper tolerance
After selecting the parameter, the currently set upper tolerance is displayed.
1. If necessary, use the
2. Change tolerance using the
Factory setting
Possible settings
F2.2.4 – Lower tolerance
After selecting the parameter, the currently set lower tolerance is displayed.
1. Use the key to activate editing if necessary.
2. Change tolerance using the
Factory setting
Possible settings
F2.3 – Reference optimization
This parameter only appears if F2.1=Count is set.
No reference optimization
OFF
Reference optimization enabled. The weighing terminal automatically determines
ON
the piece weight again when the number of parts has increased.
F2.10 – Reset F key settings
Reset all parameters F2.x(.x) to factory setting.
5.4 F3 – terminal menu
Factory settings are printed with bold characters.
F3.1 – Display settings
F3.1.1 – Timeout
The weighing terminal switches back to the weighing mode if during the set time no action
was in the menu.
Factory setting
Function disabled
Possible settings
key to activate editing.
,
10 d
0 ... full load
,
10 d
0 ... full load
60 (seconds)
0
10 ... 999 (seconds)
and keys.
and keys.
17