Consignes De Sécurité - EHEIM aquastyle16 Instrucciones De Uso

·
First put filter cartridge
two nibs of the filter lid
»
Install the interior filter on the left or right back corner of the aquarium with the suspension bracket
ation by plugging in the mains plug.
Important: The pump must not run dry!
D Cleaning
³
Disconnect the filter from the mains, and then pull upwards out of the tank.
·
Open filter lid
»
The clean the mediabox and wash out the filter cartridge. Only rinse off slightly the EHEIM SUBSTRATpro biological fil-
tering material und lukewarm water so as to preserve the bacterial lawn and to accelerate its redevelopment. After the
second or third cleaning, replace two-thirds of the filter material with new EHEIM SUBSTRATpro. Mix the rest of the used
filter material with the new material so that the bacteria cultures multiply faster. After the second or third cleaning, re-
place the filter cartridge.
E Maintenance
Disconnect the filter from the mains, and then pull upwards out of the tank.
³
Take off the pump lid
·
Take off dosing chamber lid
ing brush (order no. 4009560). Afterwards, put the pump impeller back in, and close with pump lid. Put the filter back in
the aquarium and put into operation using the mains plug.
Power-LED light
Power-LED light
F Assembly / Putting into operation
³
Insert the light fixture
·
Snap the power-LED light
Important: Mind the direction of the arrow, as otherwise it will not function.
»
Connect the power pack
the cable guide . Plug in the power pack, and switch on light with the toggle switch.
¿
We recommend installing the light about 8 cm above the surface of the water. This will produce an optimum illumination.
Français
Consignes de sécurité
Avant la mise en marche de l'aquarium, lire impérativement de manière soigneuse et intégrale le mode d'em-
ploi, et bien le conserver.
in the filter lid , then also insert mediabox in filter lid
into the grooves on the bottom of the filter housing
, and take out mediabox
, take off the pump impeller
, and clean dosing chamber
Light fixture
into the guide holes on the back of the filter.
into the light fixture and align the light such that it is centred.
and light fixture
and filter cartridge
with the pin on the pump lid and clean.
, pump chamber and outflow opening with clean-
Plug connection Cable guide
with the plug connection
6
until it clicks into place. Insert the
and shut filter lid.
.
Power pack.
and mains cable for the interior filter via
. Put into oper-