Using The Light - ALPHA-TOOLS A-ES 1000/1 Manual De Instrucciones Original

indicator (Fig. 1/Item 3) fl ashes.
3. It takes around 24 hours to charge the energy
station.
Pressing the pushbutton (Fig. 1/Item 4) displays
the charge state of the built-in battery on the inte-
grated voltage meter (Fig. 1/Item 5).
5.2 Charging the energy station with the
automobile adapter cable
The energy station can be charged through the
automobile's cigarette lighter socket.
Notice! You should only charge the energy station
when en route, as otherwise the unit will run down
the vehicle's battery.
Never start the vehicle as long as the automobile
adapter cable is connected to the cigarette lighter
socket.
Insert the 12 volt plug of the automobile adap-
ter cable into the automobile's cigarette lighter
socket and insert the other end of the cable into
the charging jack of the energy station marked
"(RECHARGE)".
6. Outputs
Caution!
Output 12 V through the cigarette lighter plug
connection.
10 Amperes max.:
•
The 12 V output (Fig. 1 / Item 12) is designed
to handle 10 A, i.e. there are max. 10 A availa-
ble to use.
•
Observe the power/electricity consumption
values of the consumer, to prevent overloa-
ding the energy station. If only the power data
of the consumer is known, the maximum
electricity value can be easily calculated.
Example calculation:
Consumer: 12V / 50W
The electricity consumption is equal to:
50W / 12V = 4.17A
•
The cigarette lighter cable provided can be
used to connect a suitable consumer.
It is protected by a 10 A fuse.
•
In order to use the 12 V output, remove the
protective cap and connect the consumer.
Anl_A_ES_1000_1_SPK7.indb 16 Anl_A_ES_1000_1_SPK7.indb 16
GB
Observe the voltage and electricity values
of the appliances to be used, in order not to
overload the energy station.
Overload could lead to destruction of the
appliance.
The ON/OFF switch (1) for the jump-start cable
must be in position "0".

7. Using the light

To switch the light on, proceed as follows:
The light (Fig. 1 Item 6) is switched ON and OFF
with the switch (Fig.1/Item 7).
8. Jump-start for motor vehicles
Danger!
•
The charging cable with pole clips are situa-
ted on the side of the appliance.
•
If you do not need the charging cable, do not
remove this from the appliance.
•
Important. Danger of short-circuit if pole clips
are contacted.
•
The energy station can only be used to
jump-start partially discharged motor vehicle
batteries. This means you can only convey a
limited capacity into the motor vehicle battery.
•
The energy station is NOT designed to
start completely discharged batteries!
The terminals are insulated to prevent accidental
short-circuiting when connecting the terminals to
the vehicle's battery and parts. Short-circuits must
be avoided at all costs.
The jump-start feature of the energy station off ers
a welcome helping hand when having start-up
diffi culties because of low battery capacity in the
motor vehicle battery.
We would like to point out that even standard
vehicles are fi tted with a whole host of electronic
equipment (such as ABS, ASR, injection pump,
on-board computer and car phone). The raised
starting voltage and occurrence of voltage peaks
could possibly lead to defects in the electronic
components when starting up. Subsequent dama-
ge caused by jump-starting cannot be covered by
the product liability insurance. Please also refer to
the instructions in the owner's manuals for the car,
radio, navigation system, etc.
- 16 -
29.07.14 13:48 29.07.14 13:48