Publicidad
Idiomas disponibles
Idiomas disponibles
1
7
4. Lift the red lever up (10) on each side of the basic
carrier bar (1). Fold the quick-release lever down (11)
and turn it to the right.
5. Place the basic carrier bar (1) as illustrated, on
the front left mounting point on the roof of the
vehicle (7), so that the feet (12) are positioned
directly over the anchorage points (13).
1
9
11
6. Press and hold the quick-release lever down (11)
on each side of the basic carrier bar (1) and turn it to
the left. Fold the quick-release lever down (11) to the
stop. Press the red lever down (10).
7. Use the tool (4) to tighten the screws (9).
8. Place the covers (6) back on and lock them with
the key (3).
9. Follow the same procedure to mount the rear
basic carrier bar (2).
10
11
12
13
M+P-03F-8020
10
M+P-03F-8021
G
WARNING
Each time the basic carrier bars are mounted to
the roof, before each trip and periodically during
longer journeys, check all the screws on the basic
carrier bars to make sure that they are secure,
and retighten them if necessary. Repeat these
checks at regular intervals depending on road
surface conditions and after every 1500 miles
(2500 km) of continuous use.
Do not use any lubricants on the screws of the
basic carrier bars. The screws could work loose
and the basic carrier bars could become detached
from your vehicle, together with the objects
attached to them, thereby injuring you and other
persons and/or causing damage to property,
including damage to your vehicle.
Attaching the cover strips
If no accessories are mounted, then the cover
strips (5) should be attached in order to minimize
wind noise.
- 31 -
Publicidad
