medi circaid juxtafit essentials Instrucciones De Uso página 4

English
English
elbow strap will be pre-applied in
its proper position for ease of use
however some adjusting to
maximize comfort and coverage
may be needed when wearing
the arm garment.
Step 1: Locate the elbow crease.
Step 2: Attach the two Velcro tabs
of one side of the elbow strap to
the arm garment next to the
elbow crease.
Step 3: Pull the elbow strap
across the elbow crease and
secure the remaining two Velcro
tabs to the other side of the
garment.
Ensure that the Velcro tabs never
make contact with the thin,
elastic material.
If desired, temporarily remove
the elbow strap to increase
mobility. The circaid juxtafit
essentials elbow strap is
symmetrical, so either end may
be used for alignment.
Doffing circaid® juxtafit®
essentials arm
Step 1: To remove the circaid
juxtafit essentials arm, detach all
bands starting with the top band.
Fold each band onto itself to keep
the Velcro tabs lint-free. Remove
the garment.
Step 2: Remove the garment.
Note
If you have decided to wear a
circaid undersleeve beneath the
garment, remove the
undersleeve.
Using the Built-In-Pressure
card:
It is recommended to always
use the BPS card packaged
with the product.
Step 1: Locate the Built-In-
Pressure card in your packaging.
Step 2: Starting with the bottom
band, line up the black triangle
on the card with one of the BPS
lines on the bottom band.
Step 3: Note where the second
BPS line lines up with the card´s
compression ranges.
Step 4: If the BPS line on the
garment either falls short (Fig. B)
or goes beyond the correct
compression range (Fig. C),
readjust the band as necessary
so that the second BPS line on
the garment is aligned with the
prescribed compression range
(Fig. A). Completely loosen the
band before reapplying it if too
much tension has been applied.
Step 5: Repeat the steps 2 - 4 for
each band going up the leg. Be
sure to adjust all bands to the
same compression level. Bands
may need adjusting throughout
the day to maintain the
prescribed compression range.
Note
If using multiple circaid juxtafit
made-to-measure garments,
only lightly apply bands
overlapping the legging below to
ensure gradient compression. Set
the remaining bands to firm and
comfortable compression or
prescribed compression level.