Shindaiwa T350 Manual De Instrucciones página 11

Assembly: Install the Blade (C350)
NOTE:
The C350 is shipped with holder A, the
safety clip, holder B, shaft bolt, and bolt
guard installed. The shaft bolt is a LEFT-
HAND THREAD AND IS REMOVED IN
A CLOCKWISE ROTATION!
1. With the gearcase output shaft facing
up, rotate the gearshaft and holder A
until the hole in holder A aligns with
the matching hole in the gearcase
flange, and then lock the holder to
the gearcase by inserting the long
end of the hex wrench through both
holes. See Figure 14.
2. Remove the shaft bolt, bolt guard and
holder B. See Figure 14.
3. Slide the safety clip off center on the
gearcase shaft. See Figure 14-A.
4. Slide the blade over the safety clip
and onto the flange on holder A.
See Figure 14-B
5. Lock the blade on the shaft by
centering the safety clip.
See Figure 14-C.
NOTE:
When installing certain blades, it may
be necessary to temporarily remove the
safety clip.
CAUTION!
Install the blade so its printed sur-
face is visible to the operator when
the brushcutter is in the normal
operating position.
6. Install holder B on the gearcase shaft.
See Figure 15.
IMPORTANT!
The machined recess in holder B must
completely surround the safety clip, and
both holders must be flat against the
surface of the blade.
7. Lock holder A to the gearcase by
inserting the long end of the hex
wrench through both holes as
done in step 1 and tighten the shaft
bolt securely with the combination
spark plug/screwdriver wrench.
See Figure 16.
8. Remove the hex wrench.
The C350 should now be completely assembled and ready for use as a brushcutter.
Shaft Bolt
Bolt Guard
Holder B
Safety
Clip
Holder A
B
Slip the blade in place
35012
Figure 14
WARNING!
The blade must fit flat against the
holder flange. The blade mount-
ing hole must be centered over the
raised boss on blade holder A.
Blade
Figure 15
Tighten the assembly
"Blade not shown for clarity"
Combination Spark Plug/
Screwdriver Wrench
Holder B
Figure 16
A
Gearcase
Shaft
35010
Hex
Wrench
Slide the safety clip off-center
C
WARNING!
Never operate the brushcutter
without the safety clip installed and
both holders tightly secured and flat
against the blade surface!
35014
35015
Hex Wrench
35011
Center the safety clip
35013
Install Holder
B
Bolt Guard
11