Throttle Cable - Shindaiwa T350 Manual De Instrucciones

Assembly: Handlebar and Throttle Assembly (C350)
1. Use the 4mm hex wrench to remove
the lower cap retaining screws from
the handlebar bracket. Remove the
cap from the bracket.
2. Position the handlebar on the outer
tube forward of the handle position-
ing label as shown in Figure 7. Reas-
semble the lower cap to the handlebar
bracket in the reverse order of disas-
sembly. See Figure 7.
3. Firmly tighten both lower cap retain-
ing screws.

Throttle Cable

1. Route the powerhead throttle cable
through the cable holder. See Figure 8.
2. Install the throttle cable sleeve
on the powerhead throttle cable.
See Figure 8.
3. Connect the stop switch wire connec-
tors (two wires). See Figure 8.
4. Connect the powerhead throttle cable
to the throttle cable from the handle-
bar. See Figure 9.
IMPORTANT!
Make sure the metal end of the
powerhead throttle cable jacket fits in
the grooved end of the cable connector
5. Center the throttle cable sleeve over
the connected cable ends and place
the assembly in the throttle cable con-
nector. See Figures 9 and 10.
6. Close the throttle cable connector
using hand pressure until you feel it
snap into place. See Figure 10.
7. Secure each end of the throttle connec-
tor with a cable tie. See Figure 11.
8. Install the hip protector on the outer
tube. See inset of Figure 11.
8
Handlebar
Bracket
Outer Tube
Lower Cap Retaining
Screws
Figure 7
Powerhead
Throttle Cable
Cable Holder
Throttle Cable Sleeve
Figure 8
Connecting Throttle
Cable Ends
Throttle Cable
Throttle Cable
Sleeve
Figure 9
Throttle Cable
Stop Switch Ter-
minals
Figure 11
Throttle
Assembly
Throttle Cable
Handlebar
Cap
Male Stop Switch
Connectors
Installing the
Connector
Sleeve
Throttle Cable
Connector
Figure 10
Hip Protector
Cable Connector
Cable Ties
35009b
Handle Positioning
Label
Female Stop Switch
Connectors
Throttle Cable
Sleeve
Handlebar