Personal Protective Equipment; Before Use; Operation; Preparing For Use - Hilti TE 7 Manual De Instrucciones

5.3.5 Personal protective equipment

The user and any other persons in the vicinity must
wear ANSI Z87.1-approved eye protection, a hard

6 Before use

6.1 Fitting the side handle 2
CAUTION
Remove the depth gauge from the side handle in order
to avoid injury.
1. Disconnect the supply cord plug from the power
outlet.

7 Operation

CAUTION
In the event of the drill bit sticking, the power tool will
pivot about its own axis. Always use the power tool with
the side handle fitted and hold it securely with both hands
so that the resulting opposing force causes the slip clutch
to release in the event of the drill bit sticking. Use clamps
or a vice to hold the workpiece securely.

7.1 Preparing for use

7.1.1 Adjusting the depth gauge 3
1. Release the side handle clamping band by turning
the handle counterclockwise.
2. Pivot the side handle into the desired position.
3. Adjust the depth gauge to the desired drilling depth.
hat, ear protection, protective gloves and breathing
protection while the machine is in use.
2. Release the side handle clamping band by turning
the handle counterclockwise.
3. Slide the side handle clamping band over the chuck
and onto the cylindrical section at the front end of
the power tool.
4. Pivot the side handle into the desired position.
5. CAUTION Check that the clamping band is en-
gaged in the groove provided on the power tool.
Secure the side handle by turning the grip clockwise.
6.2 Use of extension cords and generators or
transformers
Please refer to the "Description" section.
4. Tighten the side handle securely by turning the
grip section. This also clamps the depth gauge in
position.
7.1.2 Fitting the insert tool 4
CAUTION
Wear protective gloves when changing the insert tool.
1. Disconnect the supply cord plug from the power
outlet.
2. Check that the connection end of the insert tool is
clean and lightly greased. Clean it and grease it if
necessary.
3. Check that the sealing lip of the dust shield is clean
and in good condition. Clean the dust shield if nec-
essary or replace it if the sealing lip is found to
be damaged (please refer to the "Care and mainte-
nance" section).
4. Push the insert tool into the chuck and rotate it while
applying slight pressure until it engages in the guide
grooves.
5. Push the insert tool further into the chuck until it is
heard to engage.
en
7