Juguetronica VR Smartview Manual De Instrucciones página 10

TRIMMING OF THE MICRODRONE SMARTVIEW
FORWARD/BACKWARD
TRIMMING
THE FUNCTIONS OF THE MICRODRONE SMARTVIEW
Low battery protection:
When the battery of the Microdrone Smartview does not charge enough, the motors interrupt
their power supply and the drone does not take off. It is an automatic battery protection.
Speed Exchange:
The Microdrone Smartview has two speeds. By default, it works the slower speed. If you want
to switch to the faster speed, only have to press the left lever of power. A double beep will
warn you that there is exchanged for fast speed. Again press the power lever and you will
listen a normal beep: the drone returned to slow speed.
Acrobatics mode:
To perform a stunt with your drone, press the right lever direction. You will listen an inter-
mittent beep that will warn you that there is entered in acrobatic flight mode. Pushing the
right stick in the direction you wanna (left, right, forward or backward) and the drone will
perform a stunt in the respective direction. At the moment that you press the lever, the beep
will no longer soud.
ADVICE ON ACROBATIC FLIGHT MODE:
Confirms that the battery charge is enough when you are going to perform the stunts.
Return home:
When the Micro Drone Smartview straying too far from its position by simply pressing a
button, you can return it to the starting point.
Operation. Pay special attention to the control of the antenna to be directed to the rear of
the Microdrone Smartview. Press the button "return home automatic", a beep will sound
confirming the order. The Microdrone Smartview return flying to your position automatically.
If at any time you move the steering lever, the function is deactivated and again you will
have to control the steering.
IMPORTANT: The "return home" does the drone back to where it took off. If
you're not in the same position you were when you started flying the Microdrone
Smartview, the drone will not return to your position.
Absolute control:
When you are flying with the absolute control enabled, the microdrone Smartview moves
relative to its position, in the direction you are pointing its front (see picture). In this activated
flight mode, both the movements and the control of the drone are simple and intuitive. After
the synchronization, be sure that the
control of the front is facing the back of
the Microdrone Smartview. When you
press the "absolute control" button,
three beeps will sound and the LED
indicators microdrone Smartview flash.
The "absolute control" is enabled.
To disable this mode, press again the
"absolute control" button. Then a beep
will sound and the LEDs will stop flashing.
The "absolute control" is disabled.
When microdrone
Smartview tends
to displaceable
forward in statio-
nary flight, press
the button trim-
ming back repea-
tedly until you co-
rrect it. If it tends
to go back, do the
same with the trim-
ming of advance.
SIDE DISPLACEMENT
TRIMMING
When microdrone
Smartview
to displace to the
left in stationary
flight,
press the button
to displacement
to the right. If you
tend to go to the
right, do the same
with the left trim-
ming.
tends
trimming