Problems And Solution - Juguetronica VR Smartview Manual De Instrucciones

PROBLEMS AND SOLUTION

PROBLEM
The drone does not work
The drone does not
respond correctly to
control
INFORMATION ABOUT THE USE OF THE BATTERIES
• Do not mix different types or new to used.
• Do not recharge disposable batteries.
• The charging process should always be performed under the supervision of an adult.
• Use only recommended batteries and assure you toplace the batteries according to the pola-
rity indications "+" and "-".
• Remove the batteries when you are not using the drone.
• Remove from the control the used batteries.
• Turn off the drone when you are not using it.
• We do not recommend the use of rechargeable batteries.
• Do not short circuit the battery terminals.
• Discart the exhausted batteries in a rececly point. Do not mix batteries with organic residues
nor bury or burn them.
• Do not open a battery as it may explode and / or leak toxic liquids.
• A bad contact can cause loss of power.
• If the drone suffer any electrical interference, move it to another interference-free area and
performs a reset, turning off and on, or by removing and replacing the batteries.
• Charge the drone only with its charge cable.
JUGUETRÓNICA, SL - NIF: B83788414
www.juguetronica.com/extras/vr-microdrone-smartview
Shop: C/ Alberto Aguilera, 1 - 28015 Madrid - España
After-sales service: C/ Acuerdo, 36 - 28015 Madrid - España
Warranty and National Technical Support
The crossed-out wheeled container with indicates that the products and
batteries should not be disposed as household waste since they contain
substances harmful to the environment. Please use the collection points
for disposal.
CAUSE
1. The battery
charged.
2. The batteries of the
control are exhausted.
3. The drone
control are not properly
synchronized.
1. The batteries of the
control are exhausted.
2. The drone and control are
not synchronized.
3. A propeller is damaged or
broken.
Download App:
Gracias por adquirir este producto.
Toda la información y actualizaciones en:
SOLUTION
is not
1. Charge the battery.
2. Replace the batteries with
new ones.
3. Turn off the drone and the
and the
control and returns to perform
the synchronization step by step.
1. Replace the batteries with
new ones. Turn off the drone
and the control and again
performs the synchronization
step by step.
3. Replace the propeller
damaged by a new one.
.