dirna Bergstrom bycool COMPACT 3.0 Instrucciones De Montaje página 21

COMPACT 3.0
Place console and centre equipment in the
11
most convenient place of cabin roof. Once
centred, remove console for later installation.
Fasten supports tightening nuts until outside
12
EPDM joint of equipment is compressed,
between 3 and 6 mm.
Important: To avoid water from filtering inside
cabin, check EPDM joint tightening with unit
base, as indicated on diagram.
3-6mm.
Cabin roof
Fasten selflocked nut until
12 EPDM gasket is compressed
between 3 and 6 mm.
Tighten (4) M8 nuts to support and (4) to Unit
13
base.
EPDM gasket
10 mm*
(*) (approx. after tightening)
Air conditioning for vehicles
11
Base
Bracket
21
Check compression
thickness using a
tape measure in the
four corners.
EPDM gasket
EN
12
13