dirna Bergstrom bycool COMPACT 3.0 Instrucciones De Montaje página 21

COMPACT 3.0
Position the interior air distribution panel
11
on the front studs with (1) M6 wide-rimmed
washer and (1) M6 nut on each stud. Tighten
the nuts until the foam duct comes up against
the unit's upper foam. IMPORTANT: The
rubber ducting must being run into the
upper rubber of the unit to avoid air leaks.
11
EPDM
Gasket
Cabin roof
Upholstey
Tighten nut mentioned under point 10a until it
12
touches upper surface of front.
12
EPDM
Gasket
Cabin roof
Upholstey
Place console and centre equipment in the
13
most convenient place of cabin roof. Once
centred, remove console for later installation.
Unit base
Nut M6
Stud M6
Unit base
Nut M6 (10a)
Nut M6
Stud M6
Air conditioning for vehicles
Rubber ductings
Rubber ductings
21
EN
Foam
Interior air distribution
panel
Foam
Interior air distribution
panel