dirna Bergstrom bycool REVOLUTION Instrucciones De Montaje página 40

REVOLUTION
EN
®
Detailed instructions
about power supply installation
1
Power Cable
1- Run the power cable of the equipment to the vehicle battery, sticking the plastic supports on the rear
part of the cab and attaching it with cable ties; then with the cab folded forward pass the cable through
the lower area and fasten it with clamps and M4 screws; and as far as the battery with cable ties; the same
pitch should be used as that of the original cable. (Clean the area well before sticking the plastic supports).
On connecting the equipment to the battery this will automatically carry out a test on all its leds, and will
switch off.
IMPORTANT: Due to the complex system of electronic regulation of the equipment, the cu-
rrent connection must be made directly to the vehicle battery, and not to any other point which
services other accessories of the vehicle, taking the precaution to not invert the polarity when
making the connection (2). Inverting the polarity may result in irreparable damage to the elec-
tronic control, which is not covered by the warranty.
IMPORTANT:
To start the machine consult the User Manual.
2 2
+
-
40