Preparing The Appliance - ECG KT 300 HM Manual De Instrucciones

OPERATING INSTRUCTIONS
When you first turn the ceramic heater on, you may detect a slight odour. This is not a malfunction. This is
common with most heaters, it is harmless and it disappears in a little while, after dust or grease residue, which
settled there after a longer period of inactivity or during the manufacturing process, burns off.
The properties of the
• Ceramic heater, automatic regulation of power according to the ambient temperature.
• Two power levels (1300W/2000W) and the ECO mode allow to keep the temperature in the set range.
• Timer 1-12 hours
• Option of automatic rotation in 80° angle for even distribution of heat.
• Luxurious touch buttons
• Automatic dimming of the display brightness
• Humidifier switch with control of steam amount.
• Automatic stop of the humidifier when the water tank is empty (the heater continues to be active).
• Safety switch in case of overturning, double protection against overheating (thermistor, thermal fuse)
• Infrared light control
GB

Preparing the appliance

Remove the appliance from the packaging and assemble it: Inserte the body of the heater in the base and
secure it using screws (2pcs, included).
With regard to the above safety instructions plug the appliance into an appropriate electrical outlet.
Inserting battery in the remote control:
1. Remove the cover of the battery compartment on the back of the remote control.
2. Insert in the holder in the cover the battery CR2032 (included), pay attention to proper polarity of the
battery.
3. Insert the cover with the battery back in the remote control.
Appliance control
Preparing the humidifier:
• Before using, fill first the water tank. Make sure that the humidifier is turned off and unplugged.
• Remove the back cover and take out the tank. Fill it with water, screw the cap on properly and return it.
Make sure that the tank and its surrounding are dry and the water does not leak. In the event that water
gets into the rear compartment, drain through the outlet on the rear side of the appliance: Lift off the cover
and pull the plug, catch water in any vessel and then put the plug back in.
• Replace the back cover.
Using the humidifier:
Plug the appliance in the electrical outlet and turn the switch 0/I on on the rear side. Press
1.
the appliance.
2. Turn the humidifier control on the side of the appliance to "on" position and continuing to turn adjust the
intensity of humidification. By turning back in the position „off" you switch off the humidifier function.
3. The indicator light is green when the humidifier is active. When the water runs out, the sprayer and the fan
stop and the indicator turns red. After refilling the water (see „Setting up the humidifier") the humidifier
starts again and the indicator turns green again.
4. You can use the humidifier and the heater in the same time or independently.
Attention: To prevent damage to the appliance, before you start the humidifier you have to install tank
filled with water in the appliance.
Using the heater
5. All functions except for the power switch are inactive in the standby mode.
6. Press button to switch the appliance on. Press again to switch the appliance off.
Attention: When it is off the appliance cools for another 10 seconds until it is entirely off. These 10 seconds
are counted down on the display. Before you turn off the heater using switch 0/I, always allow this process
to finish.
32
32 32
appliance
to start