Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Initial state of the appliance after switching it on:
•
Power: Low power level heating, the indicator of low power heating is on
indicator
is off.
•
Rotating: Rotating is off, the rotation indicator
•
Timer: 0h (no time is set), the indicator
•
Temperature: The display shows the current actual temperature, the indicator
7.
You can switch between low and high power level and ECO mode using the button
Low power level: The low power level indicator
•
High power level: The high power level indicator
•
ECO mode: The indicator
•
temperature is 22°C, when the temperature drops under 18°C the high power level turns on, when the
temperature increases over 18°C, the appliance switches to low power level. When the temperature
reaches 22°C, the heater turns off. The display shows the current ambient temperature.
8.
Press
to turn on or off the rotation of the appliance. The indicator
rotation is turned off the indicator is off.
9.
Press
to set temperature or timer.
Temperature settings
•
Press
to enter the temeprature setting mode. (Use the button
and timer settings).
•
The indicator
. Is on and the value on the display flashes. Now you can set the temperaure using
buttons
in the range between 5°C ~ 35°C. You change temperature by 1⁰C with each pressing of
the buttons
•
Press
to exit the temperature setting mode, the appliance will hold the temperature you have set.
•
If you do not press any button or press other batton than
temperature ends and the display shows the room temperature.
•
The forst 10 seconds after you switch on the appliance, the temperature check is not performed. If the
ambient temperature is higher than the set temperature within 10 seconds from switching the appliance
on, the heater switches off, the indicator of high and low power mode turns off and the fan stops in 10
seconds. If the rotation function was active, the rotation stops as well. Other indicators and functions do
not change. When the ambient temperature drops under the set temperature , the heater starts again, as
well as the fan and rotation If the rotation function was activated before).
Setting the timer
•
Press
to enter the timer setting mode. The indicator
the buttons
the timer by 1h. You can change the value faster by holding the button.
•
If the displayed value is different from 0, the countdown of the timer starts and once it reaches 0 the
appliance switches to standby mode.
•
If you donot press any button or press any other button than
ends and the siplay shows the room temperature.
•
When you finish the timer setting, press
Note:
If the timer and temperature are set in the same time or Eco mode the display will show in 30 seconds intervals
the timer and room temperature setting or the Eco mode indicator („EC") If the timer is not set, the display will
show only the temperature.
Attention:
If you want to turn off the heater, always use both switches (on the control panel and with the switch 0/I).
is on, the indicators of low and high power levels are off. The default
. By holding the button you can change the value faster.
you can now set the timer in the range 0-12h. Each time you press
is off.
is off.
is on, the high power indicator
is on, the low power level indicator is off.
lights up, the display starts flashing and using
to go to the temperature setting.
, high power level
is on.
.
is off.
is on during rotation. When the
to switch between the temperature
within 5 seconds, the setting of
within 5 seconds, the timer setting
GB
you move
33
33
33
Publicidad
Tabla de contenido
