Safety Chain; Oven Dimensions - Hotpoint Ariston CP 9 VP6 DE/HA S Manual De Instrucciones

earthing wire must not be interrupted by the circuit-breaker). The supply cable
must not come into contact with surfaces with temperatures higher than 50°C.
! The installer must ensure that the correct electrical connection has been
made and that it is compliant with safety regulations.
Before connecting to the power supply, make sure that:
• The appliance is earthed and the plug is compliant with the law.
• The socket can withstand the maximum power of the appliance, which is
indicated on the data plate.
• The voltage is in the range between the values indicated on the data plate.
• The socket is compatible with the plug of the appliance. If the socket is
incompatible with the plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
! Once the appliance has been installed, the power supply cable and the
electrical socket must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by authorised technicians
only (see Assistance).
! The manufacturer declines any liability should these safety measures
not be observed.

Safety Chain

! In order to prevent the appliance from overturning accidentally, for
example in case of a child climbing onto the oven door, the safety
chains MUST be installed!
The cooker is provided with safety chains that must be fixed with a screw (not
supplied as accessory) on the wall behind the appliance, at the same height
as the fixing point on the appliance.Make sure that the chains are fixed in
the back of the cooker, as shown in the drawing, in such way to be tight and
parallel to the floor.
! When the installation process is complete, the chains must be kept in tension!
TABLE OF CHARACTERISTICS

Oven dimensions

32,9 x 59,5 x 39,4 cm
HxLxP
Volume
lt. 78
Voltage and
230/400V~ 3N 50Hz
Power supply Max 10 kW
frequency
EU Directive no 65/2014
supplementing Directive 2010/30/EU.
EU Regulation no 66/2014
implementing Directive 2009/125/EC.
Standard EN 60350-1,
Standard EN 60350-2
Energy
Standard EN 50564
Label e
Ecodesign
Energy consumption for Natural
convection – heating mode:
Convection mode
Declared energy consumption for
Forced convection Class –
heating mode: Fan assisted.
This appliance conforms to the
following European Economic
Community directives:
- 2006/95/EC dated 12/12/06 (Low
Voltage) and subsequent amendments.
- 2004/108/EC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments.
- 93/68/EEC dated 22/07/93 and
subsequent amendments.
- 2012/19/EU and subsequent
amendments.
- 1275/2008 standby/off mode.
GB
(see data plate)
17