Transporting Machine; Storing Machine; Recommended Stock Items - Nobles Speed Scrub 2601 Manual Del Operador Y Piezas

FIG. 45
SPECIFIC GRAVITY
at 275C (805F)
1.265
1.223
1.185
1.148
1.110
NOTE: Add or subtract 0.004 gravity reading for each
6_C (10_F) above or below 27_C (80_F).
4. Keep battery tops and terminals clean and dry.
To clean batteries:
a. Mix a strong solution of baking soda and water
(Figure 46).
FIG. 46
b. Brush solution sparingly over battery tops,
terminal and cable connectors.
NOTE: Do not allow baking soda solution to enter
battery cells.
c. Use wire brush to clean terminal post and
cable connections.
d. After cleaning, apply a coating of clear battery
post protectant to terminals and cable
connections.
5. Check for loose or worn cables. Replace if worn.
Speed Scrubt 2601 Cylindrical Brush (12–02)
BATTERY
CHARGE
100% CHARGED
75% CHARGED
50% CHARGED
25% CHARGED
DISCHARGED
Home Find... Go To..

TRANSPORTING MACHINE

When transporting machine by use of trailer or truck,
be certain to follow tie–down procedures below:
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1. Remove squeegee and raise scrub head.
2. Load machine using a recommended loading ramp.
To prevent machine damage, do not climb ramps
that exceed 9 degrees.
3. Position front of machine up against front of trailer
or truck. Once machine is positioned, lower scrub
head.
4. Place a block behind each drive wheel and rear
casters.
5. Place tie–down straps over top of machine and
secure straps to floor. It may be necessary to install
tie–down brackets to the floor of your trailer or truck.
NOTE: Do not use the control grips to secure machine
when transporting.
FOR SAFETY: When transporting machine, use a
recommended ramp when loading/unloading
into/off truck or trailer, use tie–down straps to
secure machine to truck or trailer.

STORING MACHINE

1. Before storing machine, be certain to flush tanks
and drain machine of all water.
2. Store machine in a dry area with squeegee
removed and scrub head in the raised position.
3. Remove recovery lid to promote air circulation.
ATTENTION: If storing machine in freezing
temperatures, be certain to drain machine of all
water. Damage due to freezing temperatures is not
covered by warranty.
ATTENTION: Do not expose machine to rain, store
indoors.

RECOMMENDED STOCK ITEMS

Refer to Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description. See example below:
OPERATION
19