Machine Setup; Attaching Squeegee Assembly; Installing Brushes - Nobles Speed Scrub 2601 Manual Del Operador Y Piezas

OPERATION

MACHINE SETUP

ATTACHING SQUEEGEE ASSEMBLY

1. Turn main power switch to the OFF position.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
2. Pull back on squeegee lift lever to raise the
squeegee mount bracket (Figure 3).
FIG. 3
3. Loosen the two thumb knobs on squeegee
assembly and slide squeegee into slots on
squeegee mount bracket (Figure 4).
FIG. 4
4. Tighten thumb knobs securely.
5. Connect vacuum hose from machine to squeegee
assembly (Figure 5).
8
Home Find... Go To..
FIG. 5

INSTALLING BRUSHES

1. Turn the main power switch to the ON position and
raise the scrub head. Press bottom half of brush
pressure switch to raise. Hold switch down until
scrub head actuator turns off (Figure 6).
FIG. 6
2. Then turn main power switch to the OFF position
after raising scrub head.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
3. Remove idler plate from scrub head by releasing
latches on top of scrub head (Figure 7).
FIG. 7
Speed Scrubt 2601 Cylindrical Brush (12–02)