Engage The Buckle Until It Clicks; See Images - Joie tilt Manual De Instrucciones

18
Correctly assembled vehicle belt is shown in
!
Waist belt pass through the rear-facing vehicle waist belt
slots, as shown in - 1.
18
!
Shoulder belt must pass through the rear-facing
vehicle shoulder belt slots, as shown in
!
The vehicle buckle tongue is engaged with the buckle
correctly, as shown in
18
Securing your Child in the child restraint

see images

-
19 20
19
15
1
3
.
18
- 2.
18
- 3.
20
Note
1. Child 0 - 6 months must use the infant body support.
2. Please install the child restraint on the vehicle seat first, and
then place the child in the child restraint.
3. After the child is placed in the seat, check whether the
shoulder harness straps are at the proper height. Please
2
refer to
Shoulder Harness Straps Height
1. Pull up the webbing adjuster, while pulling out the shoulder
harness straps to the proper length.
- 1 Webbing adjuster
8
2. Press the red button to disengage the buckle
leave the harness straps on the left and right sides of the child
restraint.
3. Place the child in the child restraint and pass both arms
through the harness straps.
!
After the child is seated, recheck whether the shoulder
harness straps are at the proper height. Please refer to
Proper Position of the Shoulder Harness Straps
Harness Straps Height Adjustment

4. Engage the buckle until it clicks.

5. Pull down the adjustment webbing and adjust it to the
proper length to make sure your child is snugly secured.
!
Make sure the space between the child and the
shoulder harness straps is about the thickness of one hand.
Proper Position of the Shoulder Harness Straps
Adjustment.
8
9
19
.
5
10
&
- 1, and then
9
& Shoulder
20
16