Allmand Night-Lite E-Serie Manual Del Operador página 15

Figure 10
Raising and Lowering The Light
Tower Mast
DANGER
Electrocution Hazard
• Raising the light tower mast in the
presence of electrical power lines
will result in death or serious injury.
Always check overhead wires and
obstructions before raising or lower-
ing the light tower mast.
WARNING
Tipover Hazard
• Before raising, lowering or operating
the tower lights, the unit must be set
up, properly leveled and stabilized.
See Pre-Operation Setup.
WARNING
Crush Hazard
• Standing under the light tower mast
while raising or lowering could result
in death or serious injury. Make sure
that there are no persons near the
portable light tower when raising or
lowering the light tower mast.
Raising the Light Tower Mast
1. Before raising the light tower mast,
adjust the tower lights to the desired
work position. See Adjusting The
Lights.
2. Turn the tower winch (A, Figure 11)
until the tower is fully raised.
B
C
A
3. Remove the hair pin cotter (A, Figure
12) and tower mast locking pin (B)
from the stowing hole shown in Figure
12. Insert the tower locking pin in the
locking hole (C), and secure with the
hair pin cotter.
A
Figure 11
B
Figure 12
Lowering the Light Tower Mast
1. Shut down the lights. See Operating
The Tower Lights.
2. Remove the hair pin cotter and tower
locking pin from the hole in the tower.
Place the tower locking pin in the
stowing hole and secure with the hair
pin cotter. See Figure 12.
3. Turn the tower winch (A, Figure 11)
until the tower is fully lowered.
C
A
15
en