Priming The Circuit - SOLAC CE4497 Instrucciones De Uso

- Replace the tank in its housing, ensuring that it
is well fitted.
- Close the lid.
FILLING OF COFFEE (FOR ESPRESSO):
- Remove the Espresso filter holder (J).
- Position the ground chosen coffee filter (L ó M)
in the filter holder
- We recommend using natural toast coffee, as
using roasted coffee may affect the operation
of the machine.
- Fill the removable filter with ground coffee (6 to
7 gr per cup to be prepared).
- If you wish to make 1 coffee, use 1 filter coffee,
fill the ladle (1 spoonful) and take the capacity
of the measuring spoon as the measure for one
coffee.
- For 2 coffees, use 2 cups filter (M), and put in
2 spoonfuls.
- Next lightly press down the ground coffee with
the back of the spoon.
- Fit the filter holder in the appliance once more.
- Position the filter holder in the coffee assem-
bly by inserting the assembly downwards and
turning it from left to right until it locks.
USE
- In normal use, with primed circuit (See below
"Priming Circuit")
- Before connecting the machine, check that
the buttons (F, G) are not pressed, and steam
control (R) is closed.
- With filled tank as per "Filling with water"
- Connect the appliance to the mains.
- Turn the appliance on using the Espresso on/
off switch (F).
- The heating icon (2) will blink on the LED
display (D).
- Blinking means it has started to heat up.
- The other icons will be on. (If they were not lit,
close the tap control (R) by turning and tighten-
ing clockwise)
- When (2) remains fixed, it indicates that it has
reached the proper temperature.
- Place one or two pre-heated cups at the filter
holder outlet.
- Press the coffee switch (G1, G2), depending
on the cups you want to fill. With G1, coffee will
come out to fill 1 cup and with G2, for 2 cups.
- With G1 a cup from set (3) will flash and with
G2, both will flash (from set 3).
- Using G1 and G2 options, coffee will stop
automatically.
- You can also press the Manual Operation
button (G), and the Manual Operation icon (5)
will flash.
- Using Manual option, coffee will come out until
you press it (G) again to stop it.
- Once serving has finished, wait a few seconds
and remove the cups with the coffee.
- Remove the filter holder and empty the
grounds from it.
- Wash the filter holder with running water and
dry it well.
- Check that the removable filter is perfectly
fitted into the filter holder.
- Fit the filter holder in the appliance once more.

PRIMING THE CIRCUIT

- (Only necessary when first starting, or when
for any cause there is not enough water in the
circuit)
- Fill the receptacle as per "Filling with water"
- Connect the appliance to the mains.
- Without fitting the filter holder (or with the filter
holder fitted, but without coffee), place a recipi-
ent under the steam pipe (I).
- Turn the appliance on using the Espresso on/
off switch (F).
- Open the steam knob (R) by turning counter-
clockwise.
- The pump will start working.
- Water will exit through the steam pipe. Wait
until approximately one cupful has exited
- To finish serving, close the steam knob (R) by
turning clockwise.
- This will complete the priming operation.
OBTAINING STEAM:
- The steam is used to foam milk for cappuccino,
and also to heat other liquids.
- With the machine hot, that is, with the Heating
Icon (2) fixed (or flashing)
- For Steam, press the Steam heating button (H)
and continue heating until the steam tempera-
ture has been reached.
- While heating, the Steam Function Icon (4) will
be flashing.