Intended Use; Power Supply - Dolmar EM411 Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
No load speed
Cutting height
Cutting width
Part number of replacement mower blade
Dimensions
(L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to
EPTA-Procedure 01/2014, are shown in the table.
Symbols
The followings show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Take particular care and attention.
Read the instruction manual.
DOUBLE INSULATION
Danger; be aware of thrown objects.
The distance between the tool and
bystanders must be at least 15 m.
Wait until all machine components have
completely stopped before touching them.
Keep the supply flexible cord away from
the cutting blades.
Beware of sharp blades. Blades continue
to rotate after the motor is switched off.
Remove the plug from the machine before
maintenance or if cord is damaged.
The noise of the machine is not more than
96 dB.
Keep hands and feet away. Do not operate
mower unless the guards and attachments
are in proper place.
During operation
(with grass basket)
When stored
(without grass basket)
EM411
-1
3,400 min
410 mm
YA00000734
L: 1,290 mm to 1,465 mm
W: 530 mm
H: 905 mm to 1,135 mm
390 mm x 530 mm x
1,070 mm
17.5 - 19.1 kg
Only for EU countries
Do not dispose of electric equipment
together with household waste material! In
observance of the European Directive, on
Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.

Intended use

The machine is intended for lawn mowing. Do not use
the machine for other purposes. Use of the machine for
operations other than the intended use could result in a
hazardous situation.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent in order to avoid a hazard.
For public low-voltage distribution
systems of between 220 V and 250 V
Switching operations of electric apparatus cause volt-
age fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.422 Ohms (for EM411),
it can be presumed that there will be no negative
effects. The mains socket used for this device must be
protected with a fuse or protective circuit breaker having
slow tripping characteristics.
10 ENGLISH
EM462
-1
2,950 min
20 mm - 75 mm
460 mm
YA00000742
L: 1,535 mm to 1,700 mm L: 1,630 mm to 1,790 mm
W: 570 mm
H: 950 mm to 1,165 mm H: 950 mm to 1,165 mm
515 mm x 570 mm x 590 mm x 570 mm x
1,125 mm 1,220 mm
27.7 - 29.2 kg 30.5 - 32.2 kg
/II
EM463S
W: 570 mm