Avoiding Material Damage; Safety Instructions Power Adapter; Assembly Instructions; Assembly Of The Dartboard - Crivit DS-1532 Manual De Instrucciones

Avoiding material damage!

• Use exclusively proper original replace-
ment tips, in order to avoid the darts
ricocheting off the dartboard. We strongly
recommend you do not use long tips for
electronic dartboards. They quickly buck-
le and easily break (Removing broken-off
tips from the dartboard – Trouble-
shooting, page 63 - 64).
• Do not allow the item to be exposed to
extreme weather conditions and tempera-
tures.
• Protect the item from moisture and damp-
ness. The electronics could be damaged.
Safety instructions power
adapter
ATTENTION!
Important information for use of the
adapter!
Note: The device gets warm during
normal use.
• Only use the adapter in connection with
the Dartboard DS-1532.
• Only use the supplied adapter!
• Only use original spare parts in the event
of a defect!
• First unplug the adapter from the wall
socket before disconnecting the adapter
from the dartboard.
• The adapter is suitable for indoor use
only. Keep away from moisture.
• If the housing or the power lead of the
device is damaged, discontinue using the
adapter.
• Disconnect the device from the mains if
not used over a longer period of time.
• The mains output line is not allowed to be
short-circuited.
52 GB/MT
• The external connection cable from this
transformer cannot be substituted; if the
cable is damaged, the transformer will
have to be scrapped.

Assembly instructions

Assembly of the dartboard

(Illustration B, C)
• Select a suitable position with approx. 3m
free space around it.
• The 'scratch line' must be at a distance of
2.37m from the dartboard. Fix the dart
board to the wall so that the centre of the
Bullseye is at a height of 1.73m above
the ground.
• Using the enclosed drilling template, mark
the respective drill holes with a pencil. The
markings "+"indicate the direction to
mount the dartboard in. The markings
"O" indicate openings on the dartboard
for permanent wall mounting. Mount the
dartboard using either the mounting de-
vice (3 screws) or permanent wall moun-
ting (4 screws). The cross at the centre of
the drill template indicates the position of
the bullseye on the dartboard. Then
mount the dartboard using the included
screws and wall plugs.

Assembly of the darts

(Illustration D)
Screw the tip and shaft together as indica-
ted into the grip and insert the unfolded
flight into the cross-slots.