Cleaning The Heating Element; Replacing The Fuse; Technical Specifications - EuroLite NSF-150A DMX Manual Del Usuario

Cleaning the heating element

The heating element should regularly be cleaned every 30 operational hours in order to avoid clogging. Use
smoke machine cleaner available at your dealer.
Procedure:
Fill cleaner into empty tank. Run the machine several times in a well-ventilated room only. The number of
repititions depends on the pollution level of the vaporizing elements. After use clean all remaining cleaner
and rinse the tank thoroughly.
The EUROLITE smoke fluids we recommend are non-hazardous to the environment and can be disposed of
via the sewage system.
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device will be damaged, it has to be replaced by a special power supply
cable available at your dealer.
If defective, please dispose of the unusable device in accordance with the current legal regulations.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Smoke-output:
Warm-up time:
Fluid consumption:
Tank capacity:
Dimensions (LxWxH):
Weight:
Fuse:
Please note: Every information is subject to change without prior notice. 05.06.2007 ©
230 V AC, 50 Hz ~
1,600 W
approx. 10 m
approx. 7 min.
approx. 100 ml/min.
2.5 l
368 x 305 x 220 mm
7 kg
F 10 A, 250 V
20/37 00027443.DOC, Verison 1.1