cecotec TOTALPURE 2500 Manual De Instrucciones página 34

ENGLISH
Fig. 25
3. Clean gently the air quality sensor inlet and outlet with wet cotton buds.
Fig. 26
4. Dry it with dry cotton buds.
5. Reassemble the air quality sensor's protective cover.
Cleaning of the pre-filter
To achieve the best performance of this filter, clean it every two months or 480 hours.
Clean the pre-filter with a wet cloth or a mild detergent to prevent the accumulation of dust.
The device must be switched off and unplugged when the filter is being cleaned. This is the
only filter that can be cleaned.
We recommend you to use the device in low power, preventing the filter from being damaged.
Before installing all the filters in the machine, please remove the plastic packaging and make
sure that the labels on the filters are outwards.
Steps to follow:
1. Switch the device off to stop the air filter.
2. Unplug the device.
3. Hold on the tabs at both sides of the air inlet panel and pull it outwards. Then, pull it up.
4. Remove the protruding part of the mesh filter before cleaning it.
5. Use a soft brush or a vacuum cleaner to remove the particles. Use water or soap to clean
the filter, then place it into the machine when it is completely dry.
6. Install the pre-filter back into the air purifier.
7. Reinstall the air inlet panel.
8. Plug the device in.
9. 9 Turn on the power and start the air purifier.
Replacing filters
After 1600 hours of usage, the power indicator light will flash slowly (in red colour when the
device is on standby mode and in blue colour when it is working).
Make sure the device is switched off and unplugged before placing the filter.
Device not used in a long time
Unplug the device (as power consumption happens even if the device is on Standby mode).
Dry the device on the inside, as this may cause malfunctions.
Store the device in a dry ventilated place.
Reference time for replacing the filter
When the total operation time reaches 1600 hours, the device's power indicator will flash at an
approximate rate of one flash per second. The power indicator light will be red when the device
is on Standby mode and blue when it is operating. The device will still work even after receiving
the notification for replacing the filter.
34
TOTALPURE 2500 / 5000 / 7500 CONNECTED
05620_05621_05622_TotalPure 2500_5000_7500_ Connected_Manual_YV_01200320.indd 34 05620_05621_05622_TotalPure 2500_5000_7500_ Connected_Manual_YV_01200320.indd 34 20/3/20 15:18 20/3/20 15:18