Safety Instructions And Prevention Of Accidente - Rupes DD108LT Manual De Uso

DD108 14-12-2007 16:43
2. SAFETY INSTRUCTIONS AND
PREVENTION OF ACCIDENTE
Before operating the machine, please read
through the operating instructions completely, fol-
low the Safety Instructions in this manual as well
as the generai Safety Instructions for Power
Tools in the accompanying booklet.
2.1. WARNING
For you own safety, do not attempt to use your
drill until the battery is fully charged and you have
read all instructions:
Remember the drill is always in an operating con-
dition as does not need to be connected to a
power supply. When not in use, place the for-
ward/ reverse switch in the neutral position.
Before drilling check that there are not electrical
cables, water or gas pipes running below the sur-
face-use a metal / voltage detector.
Do not expose either the drill or charger to rain or
water.
Do not overcharge the battery (more than 5
hours) as this could damage the battery cells.
2.2. SECURE WORK
Use clamps or a vice to hold the work. It is safer
than using your hand and it frees both hands to
operate the tool.
2.3. AVOID UNINTENTIONAL STARTING
Do not carry the tool with a finger on the switch.
2.4. ADDED SAFETY INSTRUCTIONS FOR
CORDLESS POWER TOOLS
Safety is a combination of operator common
sense and alertness at all time when the tools are
being used.
2.5. DISPOSAL OF BATTERY
Ensure battery is disposed of safely as instructed
Pagina 7
by the manufacturer.
2.6. HEALTH AND SAFETY FOR BATTERIES
General: do not put in fire, or mutilate--cells may
burst or release toxic materials. Do not short cir-
cuit cells as this may cause burns.
2.7. MAINTENANCE
Either the drill or the charger require any special
maintenance. Keep both the drill and the charger
in a dry place where they will not be expose for
frost of direct sunlight.
3. OPERATING THE TOOLS
Charging the battery pack
You tool is delivered only partly charged and
must be fully charged before use, for the fist
charge we recommend charging for 12 hours.
Take off the battery pack from the tool and
assemble the battery pack into the charger, then
put the plug of the charger into the electrical
outlet which supplies 230 volt, the red and green
light will illuminate which indicating that charging
is taking place, after charging for about five hour,
the red light will go out and the green only will illu-
minate which indicating the battery pack is fully
charged.
4. OVERLOAD PROTECT
When the power is too low or load is overload,
the drill will stop to rotation. The drill still can rota-
tion when the power is high or load is small.
Insert the battery pack
7