DD108
14-12-2007
16:43
5. KEYLESS CHUCK OPERATION
The keyless chuck on your drill/driver allows for
easy installation, removal and lock of bits and
drills. The chuck has two rotating grips. To open
or close the jaws of the chuck, hold grip and with
you free hand rotate part "A" forward and rever-
se. Do not use unnecessary force to tighten the
chuck.
5.1. AUTOMATIC-LOCK DRIVE
The Automatic-lock drive on your tool allows for
easy installation, removal and lock of screw bits
and sockets. There is a Lock-sleeve outside the
drive. To install or removal the screw bits or soc-
ket, push the lock-sleeve though the arrow direc-
tion, then use you free hand to install or removal
the bits or socket. Do not use unnecessary force
to tighten the chuck.
6. VARIABLE SPEED CONTROL
Simply apply light pressure to the trigger to start
the drill on the slow speed. Increasing the pres-
sure on the switch will increase the speed of the
drill.
7. CHANGING DIRECTION OF THE ROTATION
Set the direction of the rotation lever to F (for-
ward) and R (reverse). Noted that the direction of
8
Pagina 8
the rotation lever is locked when the on-off switch
is activated. The reversing or anti-clockwise ope-
ration enables application for tasks such as loo-
sening or removing screws.
Noted: Do not change the direction of rotation
when the drill running.
8. TORQUE ADJUSTMENTS
This feature allows setting of the torque or tighte-
ning power of your drill/driver and depending on
the application, various levels of driving power
are required. When driving larger screw diame-
ters a higher torque power is required to drive the
screw until it's properly seated. When the selec-
ted torque is reached the chuck will stop rotating.
Noted: Always stat on the lowest setting.
The Drill symbol gives the highest torque setting
and is used when drilling and for driving larger
screws.
9. MAINTENANCE
Either the drill or the charger require any special
maintenance. Keep both the drill and the charger
in a dry place where they will not be expose for
frost of direct sunlight.
10. WARNING
To assure safety and reliability, all repairs should
be performed by an Authorised Service Center or
other qualified service organizations. Only use
the recommended battery and charger. Battery
and the battery pack can not be put together with
coins, metal wares as screws and drivers to
avoid short circuit of battery or battery pack.
Battery and battery pack should be kept away
from fire sources, and should not be placed for a
long time under high temperature surroundings
(such as solar heating, heater, or any place with
temperature above 50 degree). Charge under the
regulated charging current, do not over charge
beyond the regulated charging time.
11. BATTERY / CHARGER
1. The Battery Pack (1) requires charging before
the initial use. The recommended initial charge
time is twelve hours, prior to initial use of the
Cordless Drill/Driver. Place the Charger on a