Ibiza Light FOG-BUBBLE-MACHINE Manual De Uso página 3

DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
Installation:
1. Take away all packing material especially in the nozzle.
2. Place the unit on the floor or on a level surface.
3. Loosen the cap of the fluid tank on top of the machine.
4. Add high quality water based fog liquid in the machine and screw the cap of the
fluid tank. Bad quality fog liquid will damage fog machine.
5. Pour high quality bubble liquid into the tank on the front of the machine.
6. Fog production: Plug the wired remote control (see picture) into the socket on the
rear side and press the yellow button (TIMER ON) to preheat the fog machine.
Once the machine has reached temperature, press the red button (continuous fog)
or green button (manual fog).
7. Bubble production: Plug the receiver of the wireless remote control into the
socket on the rear panel of the machine. Control the bubble production via the
wireless remote control
8. Plug the unit into an earthed mains outlet.
Important Notes:
1. After long bursts it is normal that the unit shuts down itself for a short period in order to reach again
operating temperature.
2. Often check whether there has enough fog liquid in machine. The operation will make big damage to the
machine if there has no fog liquid.
3. If the fog output is low, the unit makes an unusual noise or there is no fog output at all, please power off
and check fog liquid, fuse and power plug. If the problem hasn't been solved after checking these parts,
send it back to your dealer for repair.
Maintenance:
Please clean the fog machine regularly to avoid problems.
Close the cap of the fluid tank thoroughly after filling in fog liquid.
After about 40 hours continually use, please use 80% distilled water and 20% vinegar to remove the dirt in the
nozzle. Let the unit cool down. Disassemble the nozzle and use vinegar and a pipe cleaner to clean it. Make
sure that the unit is unobstructed.
Empty the tank and fill in cleaning fluid. Plug the unit into a wall outlet and heat it up as usually.
Run it in a well-ventilated place until the tank is empty.
Replace the nozzle. Unplug the unit and fill it with normal fog fluid..
Clean timely to extend the lifespan of machine.
Use dry cloths to clean machine and keep dry while store.
Technical parameter:
Voltage: ........................................................................................... AC 100-240V 50-60Hz
Heating element: ...................................................................................................... 1000W
Heat-up time: .............................................................................................................. 5 min
©Lotronic- 2015 Fog +Bubble machine
3