Introduction; Machine Placement; Setting Up The Big Shot Pro Machine - SIZZIX Big Shot Pro Manual De Instrucciones

1. Introduction

The Sizzix® Big Shot™ Pro Machine package includes all tools and parts necessary
for full assembly and operation. The Big Shot Pro Machine will cut and emboss
a wide variety of materials with the entire line of Ellison® and Sizzix dies and
embossing tools. See the Materials Guide (page 13) for specifics. When not in use,
place the dies in Ellison and Sizzix Storage Solutions (sold separately).

2. Machine Placement

Lift the Big Shot Pro Machine by its molded handholds at the ends of the
Machine. Place the Machine on a clean, flat, sturdy, non-skid surface at a height
and position that are comfortable for the user. No part of the Machine should
hang over the edge of the work surface.

3. Setting up the Big Shot Pro Machine

Parts included:
Item:
(1) Crank Handle
(2) Lock Washer
(3) Screw
(4) Screw Cap Cover
(5) Sliding Tray
(6) Cutting Pad
(7) Adapter Pad
(8) Premium Crease Pad
(9) Mylar Shims (
( 1 ) Crank Handle (2) Lock Washer
(6) Cutting Pad
14 1/4" x 12 1/4" x 1/8"
(36.20cm x 31.12cm x 0.32cm)
Qty:
1
1
1
1
1
1
1
1
) 2
0.1mm
(3) Screw
(7) Adapter Pad
14 1/4" x 12 1/4" x 3/16"
(36.20cm x 31.12cm x 0.50cm)
Tools required:
3mm Allen Wrench (Included)
Die Pick (Included)
3mm Allen Wrench
(4) Screw Cap Cover
(8) Premium Crease Pad
14 1/4" x 12 1/4" x 1/8"
(36.20cm x 31.12cm x 0.32cm)
3
Die Pick
(5) Sliding Tray
15 5/8" x 12 7/8" x 5/8"
(39.69cm x 32.70cm x 1.59cm)
(9) Mylar Shims
0.1mm x 2