Accessmatic Fox 1000 C Manual De Usuario página 62

1000 P
RO
Opening your life
1000 P
RO
1000 P
RO
Increase
Opening your life
1000 P
RO
Decrease
1000 P
RO
Opening your life
1000 P
RO
Increase
1000 P
RO
time
Opening your life
1000 P
RO
Decrease
time
1000 P
RO
5. CONFIGURATION OF THE AUTOMATIC CLOSING CONDITIONS
a) Hold down the SET button until "1" appears on the display, then to enter this
function setting press the UP button until "5" appears on the display, then release
the button.
b) Press the SET button again. The unit is now in the automatic shutdown condi-
Opening your life
tion setting mode. then you will see a gure "1" with a ashing dot on the screen.
c) Press the UP / DOWN button once to con gure the automatic closing condi-
tion. You can choose between "1" or "2". Figure "1" means that the door can only
be closed automatically while the limit position is in open mode.
Figure "2" means that the door can be closed automatically while the door is in
any position.
d) Press the SET button to con rm the setting, it will automatically return to the
standby state and an "II" will be displayed.
Opening your life
NOTE:
1. The closing conditions are set to "1" as the factory standard.
2. The door will only close automatically during the opening process, but will not
be able to close automatically after stopping while it is closing.
6. ADJUSTING THE LED OFF DELAY TIME
a) Hold down the SET button until "1" appears on the display, then to enter this
function setting press the UP button until "6" appears on the "6" display and then
Opening your life
release the button.
b) Press the SET button again. The unit is now in the LED o delay time setting
mode. And then you will see a gure "3" with a blinking dot on the screen.
c) Press the UP / DOWN button once to con gure the LED delay (1 ~ 9).
d) Press the UP button to increase the time, or the DOWN button to decrease the
time. The delay time is 1 minute * N, N = 1 ~ 9, the maximum delay time is 9 minu-
tes.
Opening your life
e) Press the SET button to con rm the setting, it will automatically return to the
standby state and an "II" will be displayed.
Note: The LED o delay time is set to "3 the factory standard.
Opening your life
21