Accessmatic Fox 1000 C Manual De Usuario página 67

1000 P
RO
Opening your life
1000 P
RO
Opening your life
1000 P
RO
Opening your life
1000 P
RO
Opening your life
1000 P
RO
Opening your life
1000 P
RO
D. CELL PHONE ON / OFF CONFIGURATION
Note: make sure the photocell has been installed correctly and use normally
closed contacts on the terminals of the opening motor accessories ( g. 24-25)
Also note that the Photo beam feature should be disabled if the Photo beam has
NOT been installed, otherwise the door cannot be closed, and the LED display will
show the letter "r" as an indication.
a) Hold down the SET button until "1" appears on the display, then to enter this
function setting press the UP button until "0" appears on the display and then
release the button.
b) Press the SET button again. The unit is now in the PHOTO ON / OFF setting
mode. then you will see a "0" gure appear on the screen again, but with a
ashing dot.
c) Press the UP / DOWN button once to con gure the photocell on / o switch.
You can choose between "0" or "1".
The gure "0" means that the photocell function is closed.
Figure "1" means that the photocell function is open.
d) Press the SET button to con rm the setting, it will automatically return to the
standby state and an "II" will be displayed.
Note: Photocell is set to "0" as factory default
Opening your life
26